Hydraulic Cylinder Mount
Runser Custom Machining Hydraulic Cylinder Mount
Hydraulic Cylinder Mount ONLY!
If you are not sure if you're machine does or dose not need a base. Please call with any questions or concerns! Jason (208) 539-9321
- REQUIRES WELDING
- Instructions provided
Bobcat Cylinder
Runser Custom Machining Hydraulic Cylinder
HYDRAULIC CYCLINDER ONLY!
These cylinders are specifically designed for RCM Thumbs ONLY. If you have any questions or concerns, please call. Jason (208) 539-9321.
RCM Hydraulic Cylinder:
● 1 Year Warranty included
● 130 degrees of rotational angle for maximum possible use
● Custom designed and engineered in the USA
● Designed for maximum possible stroke.
● Thumb folds up out of the way when not in use
● Designed with a stronger internal rod to prevent bending
● This cylinder utilizes factory pin on mount locations.
● Made for 3500 psi, tested at 3000 psi.
● Utilizes side ports allowing for the hoses to connect out of the way
John Deere Cylinder
Runser Custom Machining Hydraulic Cylinder
HYDRAULIC CYCLINDER ONLY!
These cylinders are specifically designed for RCM Thumbs ONLY. If you have any questions or concerns please call. Jason (208) 539-9321.
RCM Hydraulic Cylinder:
● 1 Year Warranty included
● 130 degrees of rotational angle for maximum possible use
● Custom designed and engineered in the USA
● Designed for maximum possible stroke.
● Thumb folds up out of the way when not in use
● Designed with a stronger internal rod to prevent bending
● This cylinder utilizes factory pin on mount locations.
● Made for 3500 psi, tested at 3000 psi.
● Utilizes side ports allowing for the hoses to connect out of the way
Kubota Cylinder
Runser Custom Machining Hydraulic Cylinder
HYDRAULIC CYCLINDER ONLY!
These cylinders are specifically designed for RCM Thumbs ONLY. If you have any questions or concerns please call. Jason (208) 539-9321.
RCM Hydraulic Cylinder:
● 1 Year Warranty included
● 130 degrees of rotational angle for maximum possible use
● Custom designed and engineered in the USA
● Designed for maximum possible stroke.
● Thumb folds up out of the way when not in use
● Designed with a stronger internal rod to prevent bending
● This cylinder utilizes factory pin on mount locations.
● Made for 3500 psi, tested at 3000 psi.
● Utilizes side ports allowing for the hoses to connect out of the way
Main Pin replacement
Runser Custom Machining Main Pin replacement
Main Pin ONLY!
If you are not sure what pin you're machine requires, please email or call.
- If your thumb is within the one year warranty, please email or call.
- 45mm
- 40mm
- 35mm
Seal Kit
If you purchased a thumb within the one year warranty, please email or call.
Hydraulic cylinder seal kit kit for 1.5" rod.
Call or email with any questions.
Spacers for Pins or Buckets
Runser Custom Machining Spacers
Spacers only !
If you are not sure what spacer you require, please email or call.
Spacers come as a set of two. Spacers are available for wider than standard buckets, causing spacing with the fit of the thumb; or any situation where spacers are needed.
Standard sizes
- 35mm (I.D. 1.39" O.D 2'') - 3/4"
- 40mm (I.D. 1.59" O.D 2.25'')- 1/2"
Custom sizes
When ordering custom sizes, have the length of the spacer needed. Email or call for prices and information.
- 35mm
- 40mm
- 45mm